|
Who's Online
There currently are 6040 guests and 3 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I found this service manual to be complete in every detail except for troubleshooting charts. It would be helpful if it had a set of troubleshooting charts; however it is a very good manual otherwise and for the price it is very well worth it.
;
Complete manual included schematics layouts and alignment procedure, clear to read and magnify, extremely pleased with manual and owner manual . com's service
;
perfect, i am very satisfait for the réception of the sansui r-5l service manual, thank you very much
;
Thank you, this is a rare document. Few others have it, but they charge way more for a download.
Great deal (even if you have to wait a few hours to get it).
;
The purchased manual is an high quality scan of the original Philips paper-based Service Manual. I am very satisfied!
TX-SR505/505E OPERATION CHECK-2
SPEAKER PROTECT-2 (CURRENT DETECTION)
[When] 1. Exchange power transistors (Q6050 - Q6056, Q6060 - Q6066). 2. Exchange amplifier PC board ass'y (NAAF-8779). <Note> 1. No input. 2. Do not check two or more channels at the same time. 3. Do not connect a dummy load to speaker terminal longer than 2 seconds. [Procedure] 1. Press and hold down CD button, then press STANDBY/ON button while the unit is powered on. " Test - _ " is displayed only for 5 seconds.
T e st - _
Blinks
2. Press AUX button, while " Test - _ " is displayed. The unit will be in the state of " Test-4-00 ".
T e st - 4- 00
3. Repeatedly press + (TONE) button until " Test-4-35 " is displayed.
T e st - 4- 35
4. Connect the dummy load of 3 ohms to the Front L ch speaker terminals. At this time, confirm that the speaker relay is not turned off.
T e st - 4- 35
5. Connect the dummy load of 1 ohm to the Front L ch speaker terminals. At this time, confirm that the speaker relay is turned off and " Protect " is displayed.
P rotect
Disconnect the dummy load immediately after checking the display of " Protect ".
T e st - 4- 35
6. Check other channels according to the same procedure as 4 and 5. 7. Press the STANDBY/ON button. Turn off
C lear
|
|
|
> |
|