Turning on & Using Automatic Speaker Setup
With the supplied speaker setup microphone, use the Automatic Speaker Setup function. Before using this function, connect and position all your speakers.
1
AV receiver
STANDBY/ON
Remote controller
RECEIVER
Press the [STANDBY/ON] button on the AV receiver or press the remote controller�s [RECEIVER] button followed by the [ON] button to turn on the AV receiver. Turn on the TV and select the input to which the AV receiver is connected.
or
ON
2
SETUP MIC
MIC position
Put the speaker setup microphone in the listening position, and connect it to the SETUP MIC jack on the front panel. And press [ENTER]. The automatic speaker setup starts. The whole process takes about 2 minutes.
ENTER
Auto Speaker Setup -----------------------Push Enter:Start Caution! Loud sound.
3
Auto Speaker Setup -----------------------Apply the Results
ENTER
ENTER
When you�ve �nished the setup, press the Up and Down [ ]/[ ] buttons to select �Apply the Results,� and then press [ENTER]. Disconnect the speaker setup microphone.
Check the Results Retry Retry with Test noise Level up Cancel
Selecting the Input Source
1.
Use the AV receiver�s input selector buttons to select the input source. To select the input source with the remote controller, press the [RECEIVER] button, and then use the INPUT SELECTOR buttons. Start playback. To adjust the volume, use the MASTER VOLUME control, or the remote controller�s [VOL] button.
3
MASTER VOLUME STANDBY/ON STANDBY ZONE 2
PURE AUDIO
MULTI CH
DVD
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
TAPE
TUNER
CD
PHONO
DISPLAY
2. 3.
PUSH TO OPEN
1
I0609-1
SN 29344330
(C) Copyright 2006 ONKYO CORPORATION Japan. All rights reserved.
